SUBMERSIBLE PUMPS CLEAN AND SLIGHTLY DIRTY WATER - RESIDUE PUMPS Submersible pumps Clean and slightly dirty water Clean and slightly dirty water APP flat piston submersible pump type RS 25-E The RS submersible pump is made of high-quality plastic. This pump can serve for pumping pure water In case of too low or no water level, the pump automatically stops to restart after 4 minutes for 3 seconds. If sufficient liquid is present, the pump will continue to run; if the water level is too low or nonexistent, the pump will again shut off automatically. The RS 25-E pumps liquids up to 3 mm. SKU Product Conn. kW Ltr./min Dirt throughput mm Input h. hp Volt B3.13.300 APP flat piston submersible pump type RS 25-E 1" 0.2 70 3 6 0.27 230 H2Q pump flat piston Q750 with built-in sensor H2Q flat piston Q750 equipped with innovative built-in aqua sensor with LED display. The pump has a dirt passage of 5mm. The pump starts pumping at 50mm water level and stops at 5mm water level SKU Product Conn. kW Ltr./min Dirt throughput mm Input h. hp Volt A3.02.255 H2Q pump flat piston Q750 with built-in sensor 1.1/2” 0.75 217 5 8.5 1 230 Arven MIZAR 30 LOWER - flat and vacuum pump This professional submersible pump is very compact and completely in stainless steel 304. This pump is applicable for pumping pure to slightly polluted water. The double shaft seal rotates in an oil bath. Max. temp. 35°C where the pumped water provides cooling for the motor. Max. dirt passage 2 mm. This flat piston pumps water up to 2 mm. Can be automated in combination with the Crab float SKU Product Conn. kW Ltr./min Dirt throughput mm Input h. hp Volt B3.04.505 Arven MIZAR 30 LOWER - flat and vacuum pump 1.1/4" 0.25 150 2 8 0.33 230 Internal rubber check valve 1.1/4" Internal check valve (for Arven Tox and others), no additional fittings are required when using this check valve SKU Product Conn. B5.01.534 Internal rubber check valve 1.1/4" 1.1/4" H2Q flat piston construction site pump SPA530 This pump dries up to 2 mm from the floor, thanks to the built-in rubber delay valve, the pump will operate from as low as 3 mm. The pump base is made of wear-resistant rubber, pump base is stainless steel 304 and the shaft seal is made of silicon/carbide steel. Also, the shaft sealing chamber is filled with thermal oil (available with 1" tilting output, i.e. both vertical and horizontal). Can be automated in combination with the Crab float SKU Product Conn. kW Ltr./min Dirt throughput mm Input h. hp Volt B3.14.125 H2Q flat piston construction submersible pump SPA530 1" 0.53 170 2 11 0.75 230 For our current prices, visit en.mpi-pumps.com or scan the QR code. 76
RkJQdWJsaXNoZXIy MTkyODMyNw==